Cont

Have any Questions?

+86 18626835909

May 11, 2022 View:

Notes On The Installation Of The Rotary Lobe Pump

The rotor pump is a self-priming volumetric pump, suitable for conveying neutral or lightly corrosive, clean or containing a small amount of solid particles, low or high temperature liquid media. The good or bad installation of the lobe pump directly affects the normal use at a later stage, therefore, when installing the lobe pump, the following points must be noted.

1, lobe pump in the installation process, should be fully considered in the future maintenance of the required location space.

2. adjust the ground screw of the lobe pump so that its whole is in a horizontal state; in the process of connecting the pipes, attention should be paid to the linking of the feed pipes.

3. The coupling of the feed pipe must be kept in a horizontal position to prevent residual air or gas from being left in the pipe and affecting the normal operation of the equipment.

4. For high viscosity materials a high level of feed should be used to increase the feed pressure in the feed pipe.

5、Pump sets equipped with auxiliary systems should arrange the inlet piping in strict accordance with the inlet and outlet marks on the factory equipment, no connection in the opposite direction is allowed.

6、Pump sets equipped with auxiliary systems should be wired in strict accordance with the steering marks on the pump casing, reverse rotation is not allowed. The lobe pump should not be allowed to work during the use of any small faults, and should be shut down immediately for maintenance to avoid serious consequences.